artfullpac

• Windows Embedded Posready 2009 Product Key

All network configuration and security settings are dependent upon the site’s infrastructure and configuration of the wireless network. If you encounter problems with the wireless network, see your site administrator.

Windows Embedded Posready 2009 Product Key

To connect the POSReady 2009 Wireless PCWS 2015 to a wireless network using (WPA-PSK) Wi-Fi Protected Access with Pre-Shared Key with the Ralink WLAN Utility and Ralink Configuration Tool:

1. Start the Ralink WLAN Utility.

   After the installation of the wireless network module, this utility automatically opens.

2. Click the Profile tab, and then click the Add button.
3. Click the System Config secondary tab.
4. In the SSID field, enter the SSID for your Access Point. Note that this is case sensitive.
5. Click the Auth/Encry secondary tab.

   Figure 11-2 The Authorization and Encryption tab of Ralink WLAN Utility Tool for the PCWS 2015

   Mirrorop sender registration key for android. Jul 17, 2016 - 3 min - Uploaded by TEJ THow To Download Paid Software's For Free 'FULL VERSION'. Android and Windows. Nov 6, 2016 - 3 min - Uploaded by Manish SharmaTop 3 Best Ways To Find Serial Key Of Any Software - Duration: 2:43. Tech Boom 199,175.

   
   
6. If your Access Point is using WPA2-PSK Personal Mode:
   1. For Authentication, select WPA2-PSK.
   2. For Encryption, selectAES.
   3. In the WPA Preshared Key field, enter the secure paraphrase that matches the one entered on your Access Point.
   4. Click OK.
7. If your Access Point is setup with WPA2 Enterprise Mode using AES Encryption and EAP Authentication:
   1. For Authentication, select WPA2.
   2. For Encryption, selectAES.
   3. Click the 802.1x secondary tab.
   4. Click the Client Certificate subtab, and then select Use Client Certificate.
   5. Select the certificate, and then click OK.

      Figure 11-3 The 802.1x tab of Ralink WLAN Utility Tool for the PCWS 2015

      
      
8. Select the profile you created, and then click Activate.
9. If you are using DHCP:
   1. Verify that you have an IP address, sub mask, and default gateway assigned.
   2. Click OK to close the Ralink Configuration Utility.
   3. Run the MICROS CAL normally.
10. If you are using a static IP address:
    1. Click OK to close the Ralink Configuration Utility.
    2. Click Start, click Settings, and then click Network Connections.
    3. Right-click Wireless Network Connection, and then click Properties.

       The Internet Protocol Properties dialog box opens.

    4. Select Use the following IP address, and then enter the IP, subnet, and gateway addresses.
    5. Click OK twice to close and save.
    6. Run the MICROS CAL normally.

Parent topic:Configuring the Wireless PC Workstation 2015

May 10, 2014 - 18 min - Uploaded by BrowningateIf you're concerned about Microsoft's end of support for Windows XP, you may wish to check. Windows Embedded POSReady 2009 is derived from WEPOS since Microsoft at the time of its development did not have a componentized version of Windows. Are installing Windows XP Media Center Edition 2005, you can use a Windows XP Media Center Edition Product key or a Windows XP Professional product key. May 01, 2014 If you want to use Windows XP after the end of support deadline, then Windows Embedded POSReady 2009 might be worth a look. It's basically Windows.